LightSync Digital Dimming Module
Model: LSDM-P, LSDM-R
The LightSync Digital Dimming Module is designed for 0 -10V device control. This dimmer is galvanically isolated up to 1500V and designed to be used with MC luminary style cable. This module can be installed in the lighting control panel or remotely mounted on the panel local CAT-5 network. Each of the 4 independent channels can control up to100 ballasts with 256 steps between 0 and 10V. Outputs are designed to sink voltage up to 100mA per channel. Each output may be programmed to respond to 16 inputs per channel. Upon loss of power, the dimmer outputs will go to 10V or full brightness. The intuitive software provided makes it easy to program and adjust the settings.
Cutsheets
Wiring Diagrams
Installation Guides
Specifications
Physical:
- 2.75” Wide X 3.5” High
- Removable output connectors
- Digital addressing switches
- RJ45 connectors for CAT-5 to the panel local port
Electrical:
- Powered from the panel or from the LightSync network
- 100mA sink per channel
- 0-10VDC
Configuration:
- Software programming
- Directly through keypad
Operating Environment:
- Location: Interior space
- Operating Temp.: 0° to 50° C
- Humidity: 10% - 90% Non-condensing
- Atmosphere: Non-explosive/corrosive
- Vibration: Stationary
Certifications and Approvals:
- FCC Part 15
Resources
Technical Bulletins
Product Details
Features
- Made in the USA
- Digital CAT-5 Ready
- 4 independent channels per module provide the flexibility to-control up to 4 zones
- Each output can control up to 100 Fixtures
- Galvanically isolated up to 1500V
- Power-On level settings allows each output to be configured for 0 to 100% levels upon power-up
- Power loss to dimmer module sets dimming to full brightness
- LightSync photocell tracking programmed directly to output point(s)
- Each output may be programmed to respond to 16 LightSync or hardwire inputs. Each input can be programmed to force the output to a preset level, raise or lower at 10% increments and can work in conjunction with a photocell.Inputs can be set to "revert to photocell control" after a period of time that can range from 5 to 600 minutes in 5 minute increments.
- Fade rate of 0 to 300 seconds can be programmed for each output
- Minimum and maximum output levels can be configured for each output
- With a DMX512 serial interface, each output can be con-trolled by any of the 512 DMX512 signal channels
- Panel mount (P) installs directly on output board
- Remote mount (R) provided with 4-11/16" J- box
- RJ45 connectors for remote mounting module
- Removable connectors for easy installation
- Digitally addressable